Burst Pipe Cleanup in Spokane, WA

Spokane is an old-housing town, with roughly 61 percent of homes built before 1980, and a lot of them still run on aging galvanized and copper plumbing. Those lines corrode from the inside over the decades and eventually fail under normal water pressure. When one lets go while the house is empty, it can put hundreds of gallons across the floor in an hour.

Why older Spokane plumbing fails

This kind of burst is about age, not cold. Decades of water and pressure wear the metal thin until a weak spot splits, often on an ordinary day.

• Galvanized steel that has rusted and narrowed from the inside
• Copper thinned by years of pinhole corrosion at joints and bends
• Braided supply hoses that fail at the crimp behind toilets and sinks
• Angle stops and shutoff valves that seize and split after years of steady pressure

This is a different problem from a frozen pipe, which splits because a cold snap froze the water inside. A corrosion burst can happen in July as easily as January. The EPA WaterSense program notes that a weeping fitting or a small drip is usually the early warning, so a rusty valve or a bulging hose is worth replacing before it fails.

Our burst-pipe cleanup

Once the water is off, the work is extraction and a measured dry-out, plus the repair coordination so you deal with one crew instead of three.

• Extraction of standing water from floors, cabinets, and wall bases
• Structural drying of drywall, baseboards, and flooring with daily meter readings
• Antimicrobial treatment where water sat against porous material
• Coordination with a licensed plumber to replace the failed line, hose, or fitting

When the failure is the tank rather than a supply line, that is a water heater failure, and we dry it the same way. Even in an old-plumbing home, the federal winter weather guide is worth a read, since a hard freeze can finish off a corroded line that was already on its last legs.